Abstract
The effect of solute carbon content, as well as of chromium, boron and manganese addition, on the warm rolling behavior was investigated. Both the as-rolled and recrystallized microstructures and textures were assessed after rolling at temperatures between 440 and 780°C. In an unalloyed low carbon (LC) steel, intense in-grain shear bands were formed at low rolling temperatures, but this intensity was drastically reduced at higher temperatures. Alloying with chromium and boron significantly enhanced the development of shear bands at the higher rolling temperatures. The intensities of the deformation textures produced were little changed with rolling temperature in the IF steel, but increased markedly with temperature for the LC grade. Conversely, the strength of the LC steel recrystallization texture decreased with increasing temperature. The addition of chromium to the low manganese steel somewhat strengthened the {111} component of the annealing texture at the higher rolling temperatures. However, boron addition resulted in a retained rolling component and severely disrupted the recrystallization textures. A higher manganese level was also detrimental to the development of the ND fibre components. These differences are attributed to variations in the dynamic strain aging and precipitation behaviors of the various materials attributable to their differing alloy contents.
