Abstract
The influences of the composition on abrasion resistance of composite resins were examined using various experimental composite resins which had various matrix resin, filler size and content.The abrasion test was conducted by the experimental toothbrush abrasion testing machine developed in our laboratory.Three series of heat-curing composite resins were tested.One series was made from a Bis-MPEPP or UDMA monomer, and a silica filler with an average particle size of 0.04, 1.9, 3.8, 4.3, 7.5, 13.8 and 14.1μm.The filler content of this series was constant at 45wt%.The second series contained a silica filler of 4.3μm in a content ranging from 35 to 75wt%.The third series contained a microfiller(0.04μm)and macrofiller(4.3μm)in total content of 45wt%.In this series, the microfiller was gradually replaced by 5, 15, 25 and 45wt% of the macrofiller.The results obtained for these three series indicated that the abrasion resistance of composite resins was controlled by the incrganic filler, mainly filler size and content.The abrasion loss did not vary with the difference of matrix resin.When the particle size of the filler was below about 5μm, the abrasion resistance decreased markedly with the decrease in filler size.The composite resin which contained a 0.04 or 1.9μm filler was less resistant to toothbrush wear than the unfilled matrix resin.However, the microfiller also contributed to abrasion resistance when used in combination with the macrofiller, although abrasion resistance decreased with the increase in the microfiller concentration.The increase of filler content clearly improved the abrasion resistance when used the macrofiller.The analysis of these results and SEM observations of the brushed surfaces of samples suggested that the toothbrush abrasion was three-body abrasion caused by the abrasive in the toothpaste, and affected by the difference in the particle size between abrasive and filler, and between the abrasive size and the interparticle distance of the filler.
