Journal of the Japan Society of Powder and Powder Metallurgy
Online ISSN : 1880-9014
Print ISSN : 0532-8799
ISSN-L : 0532-8799
Paper
Control the Distortion of the Large and Complex Shaped Parts by the Metal Injection Molding Process
Ryuichi HASHIKAWAToshiko OSADAKentaro KUDOFujio TSUMORIHideshi MIURA
Author information
JOURNAL OPEN ACCESS FULL-TEXT HTML

2016 Volume 63 Issue 7 Pages 473-478

Details
Abstract

Metal Injection Molding (MIM) is an effective way to manufacture small components with low cost and high precision. However, in the case of large components, it becomes difficult to control the distortion and cracking because of the big shrinkage during debinding and sintering process. Therefore it is important to optimize the condition of each process to reduce the distortion of MIM compacts. Moreover, powder size is also one of the most important parameters. The small particle powder shows high shrinkage and high density as compared to large particle powder during sintering process. In this study, blending of both powders was conducted and the influence of powder size distribution on the distortion of complex shaped parts was evaluated. A coordinate measuring machine, which is a 3D device for measuring the physical geometrical characteristics of an object, was used to measure the distortion. Finally, through controlling the distribution of particle size, distortion of the comparatively large and complex shaped MIM compacts was successfully restrained.

Content from these authors
© 2016 by Japan Society of Powder and Powder Metallurgy

本論文はCC BY-NC-NDライセンスによって許諾されています.ライセンスの内容を知りたい方は,https://creativecommons.org/licenses/by-nc-nd/4.0/deed.jaでご確認ください.
https://creativecommons.org/licenses/by-nc-nd/4.0/deed.ja
Previous article Next article
feedback
Top