Journal of the Meteorological Society of Japan. Ser. II
Online ISSN : 2186-9057
Print ISSN : 0026-1165
ISSN-L : 0026-1165
Articles
Characterization of a Three Wavelength Photoacoustic Soot Spectrometer (PASS-3) and a Photoacoustic Extinctiometer (PAX)
Tomoki NAKAYAMAHiroyuki SUZUKISatomi KAGAMITANIYuka IKEDAAkihiro UCHIYAMAYutaka MATSUMI
Author information
JOURNAL FREE ACCESS
Supplementary material

2015 Volume 93 Issue 2 Pages 285-308

Details
Abstract

 Laboratory experiments were conducted for characterizing the performance of two commercially available instruments employed for the measurement of light absorption and scattering coefficients of aerosols at λ = 405, 532, and 781 nm (using three-wavelength photoacoustic soot spectrometer; PASS-3) as well as at 375 nm (using photoacoustic extinctiometer; PAX) based on photoacoustic spectroscopy and reciprocal nephelometry, respectively. The calibration factors (conversion factors from the readout to real values) associated with scattering measurements, estimated using gaseous molecules, mono-disperse polystyrene latex and ammonium sulfate particles, and/or poly-disperse ammonium sulfate particles, are in good agreement with one another, typically within 5 %, 5 %, and 10 % at 375, 405, and 781 nm, respectively. In contrast, a significant particle size dependency was observed for the calibration factors at 532 nm, which is possibly because of a combination of differences in the polarization states of the lasers relative to the scattering planes and large truncation angle. Considering the estimated effective truncation angle, the typical uncertainties in calibration factors for scattering when measuring non- or weakly light-absorbing particles, with volume-based geometrical diameters of less than 700 nm, were estimated to be 12 %, 7 %, 34 %, and 17 %, at 375, 405, 532, and 781 nm, respectively. The typical uncertainties in the calibration factors for absorption measurements, which were determined using poly-disperse propane soot particles, were estimated to be 6 %, 4 %, 8 %, and 11 %, at 375, 405, 532, and 781 nm, respectively. The calibration factors for absorption determined by the poly-disperse soot particles at 375 and 405 nm were 48 % and 36 % smaller than those by light absorption of NO2 molecules possibly because of NO2 photolysis, although good agreement was observed at 532 nm. These results suggest that the photolysis effect should be taken into account when light absorption by NO2 is used for calibration at 375 and 405 nm.

Content from these authors
© 2015 by Meteorological Society of Japan
Previous article Next article
feedback
Top