1975 Volume 18 Issue 125 Pages 1325-1331
The present test has been carried out for the purpose of investigating the change of stresses at the circumference of force-fitted surface caused by a load acting on tooth under running conditions. Momentary change of the stresses when a slip at the force-fitted surface between gear rim and hug occurs and when this slip is repeated three to four times, has been examined. Conclusions are that by a load that acts on tooth contact point, a partial decrease of internal pressure caused by force-fitting at the circumference of the inside diameter of gear rim occurs in the part corresponding to the meshing tooth and that the limit torque for the slip in a driving test of the force-fitting gear becomes much smaller than that in a slipping test of the force-fitting gear becomes much smaller than that in a slipping test under static condition.
JSME International Journal Series C Mechanical Systems, Machine Elements and Manufacturing
JSME International Journal Series B Fluids and Thermal Engineering
JSME International Journal Series A Solid Mechanics and Material Engineering
JSME international journal. Ser. C, Dynamics, control, robotics, design and manufacturing
JSME international journal. Ser. 3, Vibration, control engineering, engineering for industry
JSME international journal. Ser. A, Mechanics and material engineering
JSME international journal. Ser. 1, Solid mechanics, strength of materials