JSME International Journal Series B Fluids and Thermal Engineering
Online ISSN : 1347-5371
Print ISSN : 1340-8054
ISSN-L : 1340-8054
Atomization Performance of an Atomizer with Internal Impingement
Muh-Rong WANGTien-Chu LINTeng-San LAIIng-Ren TSENG
Author information

2005 Volume 48 Issue 4 Pages 858-864


This paper describes the atomization performance of a newly designed atomizer with internal impinging mechanisms inside the atomizer. The spray drop size distribution was measured by a Malvern RT-Sizer. Results show that the Sauter mean diameter below 10µm has been achieved with GLR of 0.14. The minimum mean drop size can be lowered to 4.0µm under a test condition of the liquid pressure and gas pressure of 2.5bar and 3.5bar, respectively. This test suggests that extra fine atomization on the liquid phase can be achieved under low pressure conditions using this particular atomizer. Such performance cannot be easily achieved with the conventional nozzle design. Results also show that better atomization performance can be achieved by increasing the internal impinging angle and the orifice diameter. An empirical formula of SMD, in terms of operating conditions and nozzle length scale is also presented in this paper.

Information related to the author
© 2005 by The Japan Society of Mechanical Engineers
Previous article Next article