Abstract
SuperCritical Pressures (SCPs) and SuperCritical Fluids (SFCs) are widely used in many industries worldwide. The largest application of SCPs is in the power industry in advanced coal-fired power plants. It is well-known that moving from subcritical-pressure power plants to SCP power plants increases gross thermal efficiency from 38-42% to about 50-55%. Despite all advances in thermal power-plants design and operation worldwide, they are still considered as not "environmentally friendly" due to significant carbon-dioxide emissions and air pollution as a result of the combustion process. In addition, coal-fired power-plants also produce virtual mountains of slag and ash, and other gas emissions that may contribute to acid rains. Therefore, the demand for clean, non-fossil-based electricity is growing. Due to this, nuclear power is considered as a basis for future electricity generation in the world. One of the major problems with current fleet of Nuclear Power Plants (NPPs) is their relatively low thermal efficiencies, especially, of water-cooled-reactor NPPs (the vast majority of NPPs) (30-36%), compared to those of advanced thermal power plants (55-62%). Based on that, next generation or Generation-IV reactors corresponding to those NPPs should definitely be more efficient. Higher level of thermal efficiencies can be reached only due to higher temperatures and, in some cases, higher pressures inside reactors and, especially, in power cycles of Generation-IV NPPs. Analysis of the six concepts of Generation-IV reactors and NPPs shows that three reactor concepts will use SCFs as reactor coolants (helium and water) and all concepts can be linked to SCFs as working fluids in power cycles (SC helium and /or carbon dioxide in the Brayton gas-turbine cycle, and SC water in the Rankine steam-turbine cycle). Therefore, the exact knowledge of specifics of thermophysical properties of SC helium, water and carbon dioxide is very important for any advances in these new nuclear-power technologies. Also, scientists, researchers and engineers should use the same terms describing reactor coolants and power-cycle working fluids at various subcritical and SCPs. Based on that, the objective of the current paper is to define all possible terms to be used at SCPs and to link them with the appropriate regions in the Pressure-Temperature and Temperature-Specific Entropy diagrams.
