The Proceedings of the Tecnology and Society Conference
Online ISSN : 2432-9487
2024
Session ID : 103
Conference information

Project management for cooperative handicraft of low temperature differential model Stirling engine
*Yoshitaka KATO
Author information
CONFERENCE PROCEEDINGS RESTRICTED ACCESS

Details
Abstract

First grade students of Mechanical Engineering Program could not make low temperature differential Stirling engine within 270 minutes as a first year seminar. The 270 minutes means three 90-minute works. The prototype of the low temperature differential Stirling engine had been made by one person within 7 hours. The fail by the students may be caused by the papers showing the shapes of parts made of poly-vinyl chloride. The paper was designed for the paerson who made low temperature differential Stirling engine alone. Therefore, the pattern papers should be improved to promote a division of work. The project for 12 students to make a low temperature differential Stirling engine is planned. When the 12 students can use 3 hand drills, three 1.0mm-drill-bits, three 3.0mm-drill-bits, 3 countersink-drills, 3 scissors, 3 long nose pliers, 1 cutter knife, and 1 hacksaw, the planned project suggests the low temperature differential Stirling engine is made within 180miniutes. This 180 minutes means two 90-minute works.

Content from these authors
© 2024 The Japan Society of Mechanical Engineers
Previous article Next article
feedback
Top