Effect of Surface Strain to Hydroxide Layer Formation on High-Pressure Die Casting Magnesium Alloy

Abstract

Magnesium hydroxide layer improve corrosion resistance of magnesium alloys. Nonuniform strain on magnesium alloys surface was reported that affected to layer formation and corrosion resistance properties. Hydroxide layer formed to high pressure die cast ASTM AZ91D magnesium alloy, then investigated to correlation between hydroxide layer formation and residual stress and strain distribution on alloy surface which were measured by X-ray. Strain distribution was evaluated by full width half maximum (FWHM) value. Formed hydroxide layer was well compatible with FWHM distribution in as cast specimen. Heat treated for homogenization was carried out to inspection for correlation FWHM. FWHM was significantly lowering by heat treatment. Hydroxide layer tends to thin where FWHM value was low, therefore correlation between nonuniform strain and hydroxide layer formation was found out.