Abstract
It is generally recognized that one of the reasons for improvement on fatigue durability by shot peening is surface compressive residual stress. And a shot peening condition decides a residual stress profile on surface layer. But, at this moment the method to confirm this profile is only measurement by X-ray difractometer. In this study, a simulation technique was applied to predict the residual stress distribution caused by shot peening. Firstly, the residual stress on shot peened plate specimens was measured by X-ray difractometer and the effect of shot peening condition on profile was confirmed. The equation to simulate the profile was obtained by the superposition method of simple three stresses, based on the equation that Y.F. Al-Obaid suggested. It was confirmed that the predicted stress profile shows good correspondence with the experimental value every shot peening condition of this experiment.
