Journal of Networkpolymer,Japan
Online ISSN : 2434-2149
Print ISSN : 2433-3786
Original
Phase Structure and Displacement Rate Dependence of Fracture Toughness in Epoxy/Reactive Flexible Oligomer Blends
Ryohei Ono, Satoshi Matsuda, Hajime Kishi
Author information
JOURNAL RESTRICTED ACCESS

2026 Volume 47 Issue 5 Pages 267-275

Details
Abstract

The phase structure and fracture toughness of cured epoxy resins prepared by blending epoxy resin with reactive flexible oligomers consisting of long-chain aliphatic structures were investigated. Imide-terminated oligomers bearing imide rings at both chain ends exhibited higher compatibility with the epoxy resin than the corresponding oligomers before the introduction of imide rings. The cured epoxy resins were prepared by precuring at various temperatures followed by post-curing at the same temperature. The cured epoxy/reactive flexible oligomer blend the cured epoxy underwent polymerizationinduced phase separation, forming sea-island morphologies. In particular, the cured epoxy/imide-terminated reactive flexible oligomer blends formed relatively fine phase structures that were independent of the pre-curing temperature. The fracture toughness showed little dependence on the pre-curing temperature at a displacement rate of 10 mm/min; however, it was influenced by the pre-curing temperature at a under low displacement rate (0.5 mm/min). The dependence of fracture toughness on pre-curing temperature was discussed based on the results of dynamic mechanical analysis.

Content from these authors
© Japan Thermosetting Plastics Industry Association
Previous article
feedback
Top