In-situ Observation of Molten Brazing Filler Metal Permeating Gap.

Abstract

Generally, brazing is completed when the brazing filler metal permeates the gap by uniform wetting. It is believed that the joining process is completed with the formation of joint defects “voids” in the process of uniform wetting. However, previous studies have shown that what occurs when brazing is performed is non-uniform wetting. It is suggested that this non-uniform wetting is the cause of void generation. Wetting and spreading of brazing filler metal is tested on a metal plate, as described in JIS Z 3191. This is used to investigate the wetting of the brazing filler metal. However, this method does not cover the wetting of the molten brazing filler metal as it moves into the gap. Therefore, it is suggested that the JIS Z 3191 experiment is insufficient to evaluate the wetting of the molten brazing filler metal that penetrates into the gap. In this experiment, we created new specimen. It is called us “V-groove specimen”. Specimens were created with two base metals. They are pure copper and lead-free brass in which bismuth was used as an alternative element. In order to do in situ experiments, it was not possible to observe the inside of a conventional electric furnace. Therefore, we produced a furnace with a window for in-situ observation and experimented with it. As a result of experiments with V-groove specimens, it was found that there are two types of wetting of brazing filler metal. They are called “primary wetting” and “secondary wetting”. The shape of the specimen was measured and evaluated for two types of wetting. The results showed that the primary wetting was measurable in shape and spread evenly. However, the shape of the secondary wetting could not be measured, and it was found to be non-uniformly spread.