Abstract
Recently, a pulsed plasma thruster (PPT), which has advantages such as smallness, lightweight and low power consumption, has attracted attention again for the application to small satellites. Liquid propellant like water or alcohol provides higher specific impulse in comparison with conventional Teflon propellant. Nevertheless, water and alcohol propellants have problems: higher freezing point or contamination to satellites by the exhaust gas. In this study, we propose to apply DME (Di-methyl ether) to the PPT's propellant. DME can be stored as liquid, and requires no pressurant because DME has a vapor pressure of 0.6 MPa at 298 K. DME would also be potentially usable as heat transfer media, coolant, working fluid of heat pipe etc. We have designed and tested a prototyped pulse injector supplying liquid DME to discharge channels of the PPTs. Experimental results showed that the pulse injector successfully injected liquefied DME of 1.16 mg/shot, which is equivalent to the mass shot of a high power class PPT. The shape of injected liquid was dependent on the duration of the gating-pulse applied to the injector; a group of droplets were provided with a 20 ms gating-pulse duration, and a single stream with 25 ms or longer gating-pulse duration.
