Tetsu-to-Hagane
Online ISSN : 1883-2954
Print ISSN : 0021-1575
ISSN-L : 0021-1575
STUDY OF HEAT-RESISTING STEEL (XIII)
Eiichiro Asano
Author information
JOURNALS FREE ACCESS

1957 Volume 43 Issue 12 Pages 1318-1325

Details
Abstract

The precipitated particles were determined by means of X-ray diffraction, electronic microscope, chemical analysis, and selective etching for both of regular 16-25-6 alloy and 16-25-6 alloy containing Ti. Samples for X-ray diffraction test and for an electronic microscope were extracted from aged specimens by electrolytic decomposition in 3% HCl solution. For X-ray diffraction test, there were two methods. One applied the usual X-ray diffraction tester using photograph film, and another used a tester which measured the diffraction and intensity automatically with Geiger counters. The author's data were compared with the known carabides crystallographic data (from ASM Diffaction Data Cards.)
It was concluded that precipitated particles in Timken 16-25-6 alloy contained two kinds of carbides, M6C, (Fe, Cr)23C6, at least. These particles were also analysized chemically, and evidence of the presence of nitride was found simultaneously. Presence of σ phase was not found. On the other hand, the carbide M6C was observed through microscope by using selective etching reagent. Thus, with the regular 16-25-6 alloy, it was concluded that precipitated particles perhaps were M6C, (Fe, Cr)23 C6, and Cr MoN2. In the case of 16-25-6 alloy contaning Ti, the intermetallic compound M2Ti (perhaps Ni2Ti) were observed apparently, besides carbides M6C and M23C6.

Information related to the author
© The Iron and Steel Institute of Japan
Previous article Next article
feedback
Top