2016 Volume 11 Issue 2 Pages 102-113
The tribological properties of diamond-like carbon (DLC) films that were lubricated with an environmentally friendly ester-based oil were investigated. Sliding tests were performed on two types of DLC films, hydrogenated amorphous carbon (a-C:H) and tetrahedral amorphous carbon (ta-C) films, using a steel cylinder that was in contact with a steel disk coated with either a-C:H or ta-C under boundary lubrication. To compare the tribological properties of ester-based oils and other based oils, Trimethylolpropane (TMP) ester, polypropylene glycol (PPG), and poly-alpha olefin (PAO) were used as the test lubricants. The ta-C film that was lubricated with TMP ester exhibited the ultralow friction coefficient of 0.015; however, the a-C:H film that was lubricated with TMP ester did not exhibit the ultralow friction. On the other hand, results obtained by a quartz-crystal microbalance with dissipation indicated that the adsorption properties of based oils depended on the type of sensor material (carbon or iron) and the type of based oil used in the measurements. Moreover, the frequency change of based oils increased with decreases in the average frictional coefficients of the steel-steel tribopair and the DLC-steel tribopair. Results of surface analysis indicated that TMP ester formed tribofilms on the ta-C surfaces, which exhibited high viscosity and low friction. All these results suggest that the combination of the ta-C film and TMP ester is the new ultra-low-friction and environmentally friendly sliding system.
