Control of Fine Cutting Chips to Improve the Processing Environment in CFRP Drilling

抄録

Carbon fiber reinforced plastic (CFRP) is increasingly used in aerospace, automobile, and other industries. With the improvement of carbon fiber reinforced thermoplastic molding technology using thermoplastic resin, it is expected that the applications of CFRP will be expand further. Because of the following issues, CFRP is known as a difficult-to-cut material. i) Machining CFRP is difficult. ii) Its finished surface deteriorates due to delamination and uncut fiber. iii) It has a shortened tool life due to severe tool wear. In addition to these issues, we has been problem presentation of fine cutting chips generated by machining. Because these fine cutting chips may scatter in the atmosphere and adversely affect the human body and machine tools, we have established a chip disposal technology that suppresses these issues to improve the processing environment. A previous study reported that shape of the tool edge is responsible in suppressing the generation of fine cutting chips. Here, we experimentally investigated the effects of tool edge shapes on the chip collection rate and tool life. An attempt was made to determine whether the same effect can be obtained by using the outside dust-collection method which is known that the dust collection efficiency is low. We revealed that the chip collection rate increases if a tool that suppresses the generation of fine cutting chips is used instead of a conventional tool; furthermore, the tool life is insensitive to coating. In contrast, a comparison of our results with previous findings indicates that the tool with a sharpened cutting edge has a longer tool life than the conventional twist drill with honing. A high cutting chip collection rate was obtained, even with the outside dust-collection method, which led to an improvement in the working environment.