Study on Electrolyte Jet Machining of Cemented Carbide

抄録

 This paper describes a new method to electrochemically machine cemented tungsten carbide using electrolyte jet machining (EJM). NaNO₃ aqueous solution was used as the electrolyte instead of a mixed aqueous solution of NaNO₃ and NaOH, which is normally used for the conventional electrochemical machining (ECM) of cemented tungsten carbide, but has hazardous characteristics. The machining was carried out successfully with both alternating current (AC) and direct current(DC). However, AC enabled more localized dissolution under the jet than DC. An insulator nozzle was employed for AC machining to prevent the nozzle wear. It was also useful for DC machining because dissolution was more localized.