International Journal of Electrical Machining
Online ISSN : 2188-5117
Print ISSN : 1341-7908
ISSN-L : 1341-7908
Paper
High-speed Observation of Bubble Exclusion Behavior in Fine Wire EDM
Togo Shinonaga, Hidetaka Okamoto, Akira Okada
Author information
JOURNAL FREE ACCESS

2026 Volume 31 Pages 28-

Details
Abstract

In wire EDM using fine wires with diameters of 100 μm or less, the discharge area is smaller and the gap is narrower than those in conventional wire EDM with thicker wire. Therefore, discharge concentration is more likely to occur due to the stagnation of debris and bubbles in the gap, leading to unstable machining performance. In addition, the stagnation of bubbles in the machined kerf would make the debris exclusion more difficult, since the debris tends to be trapped at the bubble surface. However, the details of bubble exclusion behavior in fine wire EDM using working oil have not been clarified. This study aims to evaluate bubble exclusion behavior during process in detail and to clarify its relationships with wire EDM conditions. Observation model of fine wire EDM composed of a workpiece and an acrylic side-wall was built, and the states of bubble exclusion were observed directly by a high-speed video camera.

Content from these authors
© 2026 by the Japan Society of Electrical Machining Engineers
Previous article
feedback
Top