システム制御情報学会論文誌
Online ISSN : 2185-811X
Print ISSN : 1342-5668
ISSN-L : 1342-5668
ロバスト制御を用いた熱間仕上げ圧延機の板厚制御
岡村 義英星野 郁弥
著者情報
ジャーナル フリー

1999 年 12 巻 8 号 p. 480-488

詳細
抄録

A new gauge control system for hot finishing mills has been developed to distribute the mill motor power of each stand. The new system has the following features :
(a) Interstand exit gauge is calculated based on the law of mass flow constancy using the exit thickness gauge. (b) The design strategy of the new system are to cope with a detection time delay, and to simplify the controller to easily tune during actual implementation. (c) The H, controller with two degrees of freedom is designed to obtain high responses of the reference and disturbance. The performance of the controller is evaluated by numerical simulation. The effectiveness of the new system has been shown by application in an actual plant.

著者関連情報
© システム制御情報学会
前の記事 次の記事
feedback
Top