Vortexing Flow Patterns in a Water Model of Slab Continuous Casting Mold

抄録

A water model experiment was conducted to observe the vortexing flow in the steel slab continuous casting mold, the snake- shaped Plexiglas mold was designed to simulate the actual caster. The camera was used to record the flow patterns, which were visualized by injecting the black sesames into water. The changes of shape of single vortex and two vortices with time have been observed during experiments. A numerical model has been developed to analyze the vortexing flow, which may be produced by moving the submerged entry nozzle from center to off-center in the slab continuous casting of steel. According to the numerical results, the vortexing flow is resulted from three-dimensional biased flow in the mold. A vortex is located at the low velocity side adjacent to the submerged entry nozzle. The vortex strength depends on the local horizontal velocity of fluid and decreases gradually with distance from the free surface. The vortexing zone size depends on the biased distance of the submerged entry nozzle, and intensity of the vortexing flow depends on the casting speed of the continuous caster.