Abstract
The paper presents the results of investigations of the influence of the quality of moulding sand with furfuryl resin hardened by paratoluenosulphonic acid, on the formation of microstructure and surface quality of ductile iron castings. Within the studies different moulding sands were used: moulding sand prepared with fresh sand and moulding sands prepared with reclaimed sands of a different purification degree, determined by the ignition loss value. Various concentrations of sulphur and nitrogen in the sand moulds as a function of the ignition loss were shown in the paper as well as the gas emission and gas evaporation rate from the moulding sands. A series of experimental melts of ductile iron in moulds made of moulding sand characterized by different levels of surface-active elements (e.g. sulphur) and different gas evolution rates were performed. It was shown that there exist a significant effect of the quality of the sand on the formation of the graphite degeneration layer.
