2024 年 64 巻 4 号 p. 668-677
The dependence of crack initiation sites and main factors causing hydrogen embrittlement fracture on carbide precipitation states has been investigated for tempered martensitic steels with the same tensile strength of 1450 MPa. Notched specimens charged with hydrogen were stressed until just before fracture and subsequently unloaded. The crack initiation site exhibited intergranular (IG) fracture at 21 µm ahead of the notch tip as observed by scanning electron microscopy (SEM) for 0.28% Si specimens with plate-like carbide precipitates on prior austenite (γ) grain boundaries. This crack initiation site corresponded to the vicinity of the maximum principal stress position as analyzed by a finite element method (FEM). The initiation site corresponded to the triple junction of prior γ grain boundaries as analyzed by electron backscattered diffraction (EBSD). In contrast, the crack initiation site exhibited quasi-cleavage (QC) fracture at the notch tip for 1.88% Si specimens with fine and thin carbide particles in the grains. This crack initiation site corresponded to the maximum equivalent plastic strain site obtained by FEM. Additionally, the crack initiated on the inside of prior γ grain boundaries and propagated along the {011} slip plane with higher kernel average misorientation (KAM) values as analyzed by EBSD. These findings indicate that differences in carbide precipitation states changed the crack initiation sites and fracture morphologies involved in hydrogen embrittlement depending on mechanical factors such as stress and strain and microstructural factors.
