抄録
Metastable austenitic stainless steels undergo deformation induced transformation to bcc martensitic structure during cold-working. The martensite induced reverts to austenite at a relatively low temperature and this leads to the formation of ultra fine austenite grains of less than 1 μm in diameter. In this paper, the effect of pre-cold-working on the morphology of reversed austenite was investigated by means of transmission electron microscopy and tensile test. The alloy used is an Fe-18.08%Cr-8.65%Ni alloy. Since this alloy has metastable austenitic structure at room temperature, it almost transforms to lath-martensite by 50% cold-rolling. Further cold-rolling above 50% deforms transformed martensite itself, and results in the formation of dislocation-cell structure instead of lath-martensitic structure.
The diffusional reversion of deformation induced martensite takes place at around 900 K and precold-working to lath-martensite not only promotes the reversion but also gives a large effect on the microstructure of reversed austenite: Reversed arstenite is characterized, in a specimen with 50% pre-cold-working, by the stratum structure of austenite laths and blocks, which looks like a lath-martensitic structure, while in a specimen with heavy pre-cold-working, by the structure of fine equiaxed grains. On the discussion of grain boundary strengthening in the former case, 0.2% proof stress depends not on the lath size but on the block size of reversed austenite.
