Static Recrystallization Behaviour of a Wide Range of Austenite Grain Sizes in Microalloyed Steels

抄録

The static recrystallization kinetics of four steels microalloyed with Nb, Ti and Nb–Ti have been investigated, covering conventional and hot direct rolling conditions. The influence of the grain size on the recrystallization time has been studied for a wide range of grain sizes (20–1000 μm). For the same deformation conditions it has been observed that the quadratic dependence on grain size works well in the range of finergrain sizes (<160 μm). In contrast, the recrystallization times measured at coarse grain sizes are significantly lower than those predicted by this dependence. However, when the whole grain size range analysed is considered, a linear dependence on grain size gives the best fit to experimental data. The effect of strain on the recrystallization kinetics has been also analysed for different initial grain sizes. It has been observed that the time to reach a 50% recrystallized fraction (t_0.5) shows a dependence on strain of the type t_0.5∝ε^-p, the exponent being influenced by the initial grain size. A unique equation has been proposed to describe the static recrystallization kinetics of Nb, Ti and Nb–Ti microalloyed steels. The predictions of the equations have been compared to previously published data on similar steels.