抄録
The machining and heat treatment, employed in the fabrication of ADI parts, produce distortions and residual stresses that can increase the scrap rate. In the present study, dimensional changes, shape distortions and residual stresses due to machining and austempering were determined on internal gears of different chemical compositions, as-cast microstructures and machining-thermal cycle sequences. The influence of chemical composition and as-cast microstructure on dimensional change were found to be in accordance with the predictions obtained by Fuzzy modelling. Shape distortion resulted in an ovalization, whose magnitude depends upon the variation range of the residual stresses due to machining. Whereas residual stresses due to austempering were found to increase when the ovalization increases.
The lack of information about the topics here studied, turn these results into a useful contribution to improve the fabrication quality of ADI internal gears. Besides, most of them can be applied to ADI parts in general.
