抄録
Effects of anodizing conditions on corrosion resistance of Mg–Li–Y alloy, which is most prominent super light alloy capable for easy deformation, were investigated with attention to the formation behavior and microstructure of anodic films. Barrier films or semi-barrier films were formed except at around 7 V and breakdown voltages similar to those associated with typical pure magnesium and AZ alloys. At the former voltages, thick porous type films were formed. The critical voltage of high current flow accompanied by breakdown was dependent on substrate composition; 45 V for Mg–Li–Y alloy, 60 V for 99.95% Mg and 120 V for AZ91D. When aluminate or phosphate ion was added in the electrolyte, the critical voltage of Mg–Li–Y alloy increased to 100 V. Lithium was highly enriched at the outer part of the film and yttrium was enriched in the middle to inner part when the film was barrier type. The ratio of barrier film thickness to anodizing voltage was as high as 4.25 nm/V compared to 1.9 nm/V of that associated with 99.95% Mg. When the film was porous type, the content of both lithium and yttrium decreased and distribution of both elements became uniform. Anodic films formed in sodium phosphate solution followed by sealing treatment in silicate exhibited sufficient corrosion resistance for practical usage.
