Journal of the Japan Society of Powder and Powder Metallurgy
Online ISSN : 1880-9014
Print ISSN : 0532-8799
ISSN-L : 0532-8799
Tensile Properties at High Temperature of Sintered TiAl Compacts by Injection Molding
Kiyotaka KatoAkihiro MatsumotoTei Ieki
Author information
JOURNAL OPEN ACCESS

1997 Volume 44 Issue 11 Pages 1029-1034

Details
Abstract
In this paper, tensile properties at high temperature were investigated on the sintered TiAI compacts produced by MIM process. The sintered Ti-45A1, Ti-48AI, Ti-50A1 and Ti-52A1(at.%) compacts showed the relative densities more than 95% by sintering at 13751 for.2hr in vacuum(10-2Pa order).
The results obtained were summarized as follows:
(1) The tensile strengths at 800°C for Ti-45A1, Ti-48AI and Ti-50Al compacts were almost equal to the strength at room temperature, which were in the range of 370 to 400MPa. The Ti-52Al compact showed smaller tensile strength at 800°C(330MPa) than the strength at room temperature(430MPa). The elongations at 800°C for TiAl compacts increased with increasing Al content. Especially, the Ti-52A1 compact showed the highest elongation of 13%.
(2) The tensile strengths at 1000°C for all TiAI compacts were smaller(-200MPa) than the strength at 800°C, which were sligthly increased with decreasing Al content. The elongations at 1000°C were still more than 10%.
Content from these authors
© Japan Society of Powder and Powder Metallurgy

本論文はCC BY-NC-NDライセンスによって許諾されています.ライセンスの内容を知りたい方は,https://creativecommons.org/licenses/by-nc-nd/4.0/deed.jaでご確認ください.
https://creativecommons.org/licenses/by-nc-nd/4.0/deed.ja
Previous article Next article
feedback
Top