日本複合材料学会誌
Online ISSN : 1884-8559
Print ISSN : 0385-2563
ISSN-L : 0385-2563
研究論文
厚板CFRTPの部分曲げ加工におけるシワの発生とその機械特性の評価
布谷 勝彦森 大介鵜澤 潔
著者情報
ジャーナル フリー

2022 年 48 巻 1 号 p. 22-31

詳細
抄録

In recent decades, the CFRTP press-forming process has drawn intense research interest because of its use in automobile and industrial equipment. However, it is still very challenging to cost-effectively fabricate large, long, and thick CFRTP parts, such as infrastructure and general-purpose structures. Therefore, the authors propose the partial bend-forming of thick CFRTP laminates via partial heating. While bend-forming has the potential for low-power heating and low-load pressing, this process always causes wrinkles in the bent area. The purpose of this paper is to clarify the effect of wrinkles in the bent area for the development of a new process that applies bend-forming. The wrinkles caused by a partial bend-forming experiment were observed, and strength and stiffness were evaluated by a 4-point bending test using L-shaped specimens containing wrinkles. Forming simulation of the partial bend-forming was also attempted. It was found that the bent section with wrinkles had lower strength but comparable stiffness compared to the bent section without wrinkles. When running forming simulations of wrinkling with delamination, it was found that the definition of the interlayer separation stress was important. The simulation results were in good agreement with the experimental results.

著者関連情報
© 2022 日本複合材料学会
前の記事 次の記事
feedback
Top