Analysis of Dynamic Tooth Load on Planetary Gear

抄録

The authors studied theoretically the vibration of a single-stage Stoeckicht planetary gear (Type 2K-H) constructed with spur gears, and calculated the fillet stress, the dynamic tooth load and the load distribution, Furthermore they indicated that the calculated results nearly coincide with the measured ones. The results are as follows. (i) The inequality of load distribution due to the run-out error can be eliminated by using the floated sun gear. Therefore the mean load distribution rates for each planet gear are nearly equal. (ii) But it is difficult to eliminate the inequality of load distribution due to the vibration of tooth profile error and tooth stiffness. (iii) The run-out errors bring about the torque variation of lower and higher speed shafts.