Investigation about Load Capacity of Nylon Gears, When Tooth Surface Finishing of Mating Steel Gears is different. : 1st Report ; Results of Load Test at Cylinder
1981 年 24 巻 198 号 p. 2194-2202
詳細
1981 年 24 巻 198 号 p. 2194-2202
There are many reports on fundamental experiment of "Nylon-Steel" abrasion. But these are a little used for actual gear. This report discusses a nylon gear meshing with a hobbed steel gear and a ground steel gear. The load test of nylon cylinder was performed using a steel cylinder which has a different surface finishing. The abrasion, the allowable limit load, the surface temperature, the modes of breakage of nylon cylinder owing to a difference of a surface finishing of steel cylinder were investigated and useful data for design of nylon gear were collected.
JSME International Journal Series C Mechanical Systems, Machine Elements and Manufacturing
JSME International Journal Series B Fluids and Thermal Engineering
JSME International Journal Series A Solid Mechanics and Material Engineering
JSME international journal. Ser. C, Dynamics, control, robotics, design and manufacturing
JSME international journal. Ser. 3, Vibration, control engineering, engineering for industry
JSME international journal. Ser. A, Mechanics and material engineering
JSME international journal. Ser. 1, Solid mechanics, strength of materials
