2006 年 49 巻 1 号 p. 56-62
A Wolter type I aspheric mirror which is a key optical element used in a soft X-ray microscope requires super smooth surface and highly accurate figure. This paper deals with fabrication of the Wolter type I microscope mirror by an epoxy replication method. The required figure accuracy of the mirror optimized with surface roughness of 2nm rms and photon energy of 539eV was estimated for a prototype soft X-ray microscope. A master mandrel was prepared by single-point diamond turning and polishing, and a precise aspheric gold mirror with axial symmetry was successfully obtained from the master mandrel through replication processes. The fabricated mirror showed surface roughness of 1.12nm Ra and figure error of 34nm rms, and several mirrors could be obtained from only one master mandrel without destroying its surface roughness and shape.
JSME international journal. Ser. 1, Solid mechanics, strength of materials
JSME international journal. Ser. A, Mechanics and material engineering
JSME international journal. Ser. 3, Vibration, control engineering, engineering for industry
JSME international journal. Ser. C, Dynamics, control, robotics, design and manufacturing
JSME International Journal Series A Solid Mechanics and Material Engineering
JSME International Journal Series B Fluids and Thermal Engineering