計算力学講演会講演論文集
Online ISSN : 2424-2799
セッションID: 4_224
会議情報

組み立て時の製品変形を考慮した公差解析手法
玉置 斉慶川 源太渡辺 和英桑原 孝幸
著者情報
会議録・要旨集 フリー

詳細
抄録

In recent years, 3D-clearance analysis is used in the manufacturing industry. By using the clearance analysis, we can check the interference between the components. On the other hand, many products have been reduced in thickness for lightweight and cost reduction, so we have to check deformation of a product at the time of assembly of components. But it was too difficult for us to check deformation at the time of assembling because clearance analysis cannot express the deformation. In this paper, we show the way to combine clearance analysis with FEM analysis by quality engineering.

著者関連情報
© 2016 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top