抄録
In this study bubble behavior in subcooled flow boiling in an upward rectangular channel was discussed. Filtrated and deionized tap water was used as a working fluid. Heated surface is produced by cupper with high wetability or low contact angle (18°). Subcooled flow boiling is beginning with onset of nucleate boiling (ONB) which surface temperature is higher than saturation temperature while liquid temperature is less than saturation temperature. At various pressure, mass fluxes and inlet temperatures ONB heat flux is detected within observation incipient nucleate bubbles through high speed video camera. Comparing with available ONB correlations, it is revealed that surface wettability is a significant parameter. Among ΔT_<w,ONB> correlation only Basu et al. (2002)'s correlation has a good consistency with experimental data, and other correlations are most underpredicted. Nucleation rate of bubbles after ONB remain in very small amount until a specific condition nominated onset of significant void (OSV) or incipient point of net vapor generation (IPNVG) that void fraction drastically increased. Levy (1967) was the first to postulate bubble departure mechanism for OSV and many researchers believed this assumption and analytically and empirically proposed OSV correlation. However, in all the experimental conditions even at incipient bubble nucleation, bubbles are observed depart or lift-off from activated nucleation site on the heated surface. Bubble nucleation behavior as whether bubble Lift-off from hot surface or sliding along it are investigated. It is performed for low void fraction condition. It is concluded that lifting-off condition occurred when bubble size and subcooling temperature is high and sliding phenomena in the opposite condition happened. Bubble size dramatically drop down after atmospheric pressure. This categorization is useful for developing new OSV mechanism regarded to actual situation.
