年次大会
Online ISSN : 2424-2667
ISSN-L : 2424-2667
セッションID: J044023
会議情報
J044023 光ファイバ屈折率センサを用いたFRP積層板の成形モニタリング
高坂 達郎松本 明大梶川 拓矢忽那 篤楠川 量啓
著者情報
会議録・要旨集 フリー

詳細
抄録
In the present paper, process monitoring of GFRP laminates during a hot-press molding was conducted by fiber-optic index sensors. From the measured optical power, it appeared that the transverse molding pressure of 0.5MPa applied to optical fibers did not affect the sensor outputs. It was also found that resin flow which covered the sensing part was clearly indicated as sudden fall of the reflected optical intensity. The refractive index curves obtained from the sensor outputs showed that large fluctuation existed in the sensor signal due to scattering from air-voids in resin. The fluctuation disappeared within 20 minutes because the voids were vacuumed. The trend of index curve turned from decrease to increase because of proceeding of cure reaction and then became constant when cure reaction finished. From these results, it appeared that the embedded refractive index sensor could detect resin flow and void vacuuming as well as degree of cure.
著者関連情報
© 2012 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top