年次大会講演論文集
Online ISSN : 2433-1325
会議情報
2203 MEMS 技術を用いたマイクロターボ機械
カン ピルチュン田中 秀治江刺 正喜
著者情報
会議録・要旨集 フリー

p. 315-316

詳細
抄録
This paper describes the design, fabrication and test of a MEMS-based micro turbo machinery. In this device, a compressor and a turbine are formed on the same side of the rotor to escape miss-alignment during bonding process. The rotor is supported by hydrostatic journal and thrust bearings. The device rotated only at low rotation speed up to 2500 rpm, and the rotation speed did not remarkably changed by adjusting air supplies to the hydrostatic bearings. From the test results, we found important problems to be solved for high speed rotation. Concerning to fabrication, flat and smooth bearing surfaces is difficult to fabricate, and a bearing gap is difficult to precisely control due to spikes on etched surfaces and the warp of the devices induced by anodic bonding. The other concerning is bearing design. The journal bearing has a very low L/D number(length divided by diameter). As a result, the journal bearing has a small journal surface, and it is difficult to install the restriction on the journal bearing. Additionally, there is interference between the journal and thrust bearing due to air leakage.
著者関連情報
© 2003 一般社団法人日本機械学会
前の記事 次の記事
feedback
Top