生産加工・工作機械部門講演会 : 生産と加工に関する学術講演会
Online ISSN : 2424-3094
会議情報
504 小径ボールエンドミルによる高硬度材の高速加工における工具寿命に関する研究
岩部 洋育山口 恒志中西 賢介
著者情報
会議録・要旨集 フリー

p. 63-64

詳細
抄録
In this paper, the flank wear and the surface roughness of machined surface are investigated by high speed milling of hardened steel for a small size ball end mill using a high speed spindle attachment. And also it is investigated that the influence of a tool life on the inclination angle of work piece and the minimum quality lubrication (MQL) method. By the results, it is shown that the long tool life and the small surface roughness are obtained by the conditions of step up milling, down milling and the MQL method to end point of cutting. But bidirectional milling is most efficient method than other type of milling.
著者関連情報
© 2002 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top