2004 年 45 巻 8 号 p. 2653-2656
In order to obtain a sharply textured silver sheet with a single orientation as a substrate, which is favorable for high temperature superconductor (HTS) film having high Jc (critical current density), the sheet metallurgical processing of pre-heated rolling combined with two step annealing treatment has been performed. We used two kinds of starting material, which are silver ingots of commercial purity obtained by casting in air and vacuum, to examine the effect of oxygen on texture development. The main feature of warm rolling texture obtained in this study was a strong Brass {011}‹211› component with minor S {123}‹412› component, and in some cases, cube {001}‹100› component or Copper {112}‹111› component appears also depending on the warm rolling procedures. Upon crystallization, it has been found that cube {001}‹100›, {124}‹4, 12, 7› and {13, 6, 15}‹365› orientations were formed as the dominant components in silver sheets and the relative amount of their orientation components depended on the concrete annealing conditions applied after the warm rolling and on the oxygen content. A very sharp single-crystal like cube texture has been successfully obtained in the specimen, which was cast “in vacuum”, warm rolled at 95 percent and subsequently annealed 10 minutes at 150°C and 30 minutes at 500°C in nitrogen. Finally, we discussed the technological basis on sharp cube texture formation in fcc pure metals with low stacking fault energy.
