2021 Volume 7 Pages 21-00163
In this study, we developed a method for obtaining high contributing part (reference point) to the response point at the operational condition by operational TPA (OTPA) using several measurement systems. OTPA calculates contribution of each reference point to the response point using only operational signals. All reference and response signals are necessary to be measured simultaneously by single measurement system because the method calculates the contribution using their correlation along time. However, this occasionally requires preparing large measurement system depending on the number of measurement points and the size of products. This may decrease the applicability of the method. We then considered a post processing procedure to obtain accurate contribution of each reference point to the response point by using several measurement systems instead of preparing large single measurement system. In the proposed method, all signals are measured using different several systems at around same timing. The exact sampling timing gaps among systems are estimated by using the estimation error between the calculated and actual measured response signal. After then, all reference signals compensated by the estimated time gap in each system are regarded to be measured simultaneously and contribution of all reference signals are calculated by OTPA. As the verification of the proposed method, the procedure was applied to a simple vehicle model. As the result, the contribution of the proposed method was similar with the contribution by single measurement system and clarified to have an ability to obtain correct contribution by several measurement systems.
