Proceedings of JSPE Semestrial Meeting
2011 JSPE Autumn Conference
Session ID : G07
Conference information

Influence of DLC Film Type on Cutting Performance of Aluminum Alloys
*Tomohiro YokotaKentaro YoshidaMasahiro Yokouchi
Author information
CONFERENCE PROCEEDINGS FREE ACCESS

Details
Abstract
There are few technical papers which discuss the cutting performance for the different types of DLC coatings. In this paper, the cutting performance for aluminum alloys using two types of DLC coating, ta-C and a-C:H, was evaluated. A ball-on-disk friction test and a cutting test were conducted with ta-C, a-C:H and a non-coated cemented carbide. The result of friction test showed that the friction coefficients of DLC films against aluminum alloy A5052 were significantly low compared with that of a non-coated cemented carbide. For the cutting test, the ta-C coated tool showed superior cutting performance compared with that of a-C:H in dry.
Content from these authors
© 2011 The Japan Society for Precision Engineering
Previous article Next article
feedback
Top