Recompression of Augmented Vertebrae after Balloon Kyphoplasty is a Risk of Adjacent Vertebral Fracture

抄録

Introduction

This study aimed to identify factors associated with adjacent vertebral fracture (AVF) incidence after balloon kyphoplasty (BKP).

Methods

To perform the analyses, 133 vertebrae of 128 patients who underwent BKP for osteoporotic vertebral compression fracture were retrospectively investigated. According to the presence of AVF throughout a 1-year period following BKP, patients were divided into AVF (n = 22) and non-AVF (n = 111) groups. The groups were compared with respect to pre- and postoperative parameters, including the incidence of recompression of augmented vertebrae (RAV). RAV was defined as a decrease in anterior vertebral body height of at least 5 mm within the 3 months that followed BKP. To identify factors associated with AVF incidence, univariate and multivariate analyses were performed.

Results

The univariate analysis revealed that the AVF group had a lower cement augmentation ratio, greater preoperative wedge angle, lower preoperative vertebral body height, lower postoperative vertebral body height 3 months post-BKP, and a greater change in vertebral body height and rate of RAV than the non-AVF group. Multivariate analysis revealed that low preoperative vertebral body height and RAV occurrence were associated with AVF incidence.

Conclusions

To the best of our knowledge, this study is the first to indicate that RAV is a risk factor for AVF. Study findings indicate that the incidence of AVF can be decreased if RAV development is avoided.