論文ID: 2023-0006
The aim of this study was to investigate the effects of combining mechanical (ultrasonic) and chemical cleaning (using denture cleaners) on the surface roughness of silicone or acrylic soft relining materials. The silicone soft relining material with the lowest Shore A hardness and a acrylic soft relining material routinely used in Japan were selected. Four groups were established based on type of treatment: immersion in water (W); ultrasonic cleaning in tap water (U); ultrasonic cleaning in a hypochlorous acid denture cleanser (HU); or ultrasonic cleaning in an acidic denture cleanser (AU). Following the tests, surface roughness was determined as the arithmetic mean height of the surface (Sa) and maximum height (Sz). Data were analyzed using the Kruskal-Wallis test followed by Bonferroni correction for a multiple comparison. No significant difference was observed in the Sa or Sz of the silicone soft relining material between the 4 groups. Significant differences were observed in the Sa of the acrylic soft relining material between Groups W and HU (p=0.008) and between Groups W and AU (p=0.008), but no significant differences in the Sz among the 4 groups. Combining U with AU or U with HU yielded no increase in the surface roughness of the silicon soft relining material. The surface roughness of the acrylic soft relining material showed an increase, however, with the combination treatments used.
