Online ISSN : 1883-2954
Print ISSN : 0021-1575
ISSN-L : 0021-1575
Regular Article
Numerical Analysis Model of Electric Resistance Welding Pipe
Nobuhiro OkadaHiroki SakamotoTakamasa MatsuoKouji Takatani
Author information

2012 Volume 98 Issue 7 Pages 368-377


Electric Resistance Welding (ERW) pipe is widely applied for structural and mechanical use because of its simple process and high productivity. It is very important to decrease welding defects of ERW pipe because it has been requested high quality as same level as seamless steel pipes recently. Although ERW process is simple, relationships of the defects and its process conditions have not been cleared definitely. It is difficult to make clear effects of each controlled parameters of ERW, because some controlled parameters cooperate to affect the welding condition. Numerical analysis model is very useful method to study the effect of only one factor, but these are a few studies of numerical analysis model of ERW process. To quantitatively calculate ERW using induction heating, it is necessary to use non-linear magnetic property, but theses previous analysis models calculated with linear magnetic property. In this study, 3-dimensional numerical analysis model of ERW process using non-linear magnetic property has been developed and studied the influence of controlled parameters of ERW process on the welding conditions. Temperature distribution of welding edge calculated by this model agreed with the shape of heat affected zone, and it is revealed that V-angle and impeder core position strongly effect the welding power and the heating condition.

Information related to the author
© 2012 The Iron and Steel Institute of Japan
Previous article Next article