高W高速度鋼およびMo高速度鋼における熱処理と炭化物の挙動について

電解分離による高速度鋼の炭化物に関する研究-II

抄録

The total amounts of carbides in the several heat-treated specimens of the high-W high speed steels and Mo high speed steels were determined by electrolytic isolation method in this 2nd report like thd 1st (Tetsu-to-Hagane, 1958, Vol. 44, p. 1186).
Chemical compositions and crystalline structures of the isolated carbides were determined by chemical analysis and X-ray diffraction, and the shapes of the carbides were observed by an electron microscope, and the following results were obtained:
(1) On the as-annealed states, the amounts of carbides in high-W high speed steel were about 30%, and in Mo high speed steel were about 23%, and about 95% of the W, 80% of the V in the steels, and 90% of the Mo in the Mo high speed steel were concentrated in the carbides, while the most portions of the Si and Mn were dissolved in the matrix.
The carbides precipitated in these annealed steels were M₆C, MC and M₂₃C₆, and the most portions of the carbides were M₆C.
(2) In quenched states, the amounts of insoluble carbides in these high speed steels were 10-14%, which was the same about 40-45% of the carbides in as-annealed state.
The insoluble carbides in quenched high-W high speed steels were only M₆C, but the carbide in quenched Mo high speed steel consisted of M₆C and MC.
(3) The higher tempering temperature, the more precipitated the carbides from the austenite. And, especially, the concentration percentage of the special alloy elements in the carbides increased suddenly by the tempering to 575°C.
The M₂₃C₆ carbide, precipitated in the high-W high speed steel by the tempering to 750°C, and the amount of MC carbides in the Mo high speed steel increased by the tempering, and M₂₃C₆ carbide appeared by the tempering to above 575°C.