鉄と鋼
Online ISSN : 1883-2954
Print ISSN : 0021-1575
ISSN-L : 0021-1575
少量粉末試料の組成分析におけるX線マイクロアナライザーの利用
佐々木 稔鈴木 堅市卯月 淑夫
著者情報
ジャーナル オープンアクセス

1971 年 57 巻 12 号 p. 1784-1791

詳細
抄録
A method for composition analysis of microgram amounts of powder sample has been developed.
The sample was ground to the size less than 2 or 3 microns, homogeneously dispersed an organic solvent and filtrated under reducing pressure. In the filtrating procedure Nuclepore Filter of pore size of 0.5 micron was used. Prepared cake was analyzed by powder method of X-ray diffraction.
The diffraction pattern from the filter paper did not obstruct the identification of patterns from the examined samples.
Then, X-ray microanalysis was applied to the cake which was coated with carbon film. For quantitative analysis the amount of the cake on filter paper had to be over 10 micrograms per square millimeters of the paper. The content of each compound in the sample was estimated by combining the both analytical results.
Applicability of this method was checked in the analysis of a foreign substance of small quantity, formed on or contained in steel sheet.
著者関連情報
© 一般社団法人 日本鉄鋼協会

This article is licensed under a Creative Commons [Attribution-NonCommercial-NoDerivatives 4.0 International] license.
https://creativecommons.org/licenses/by-nc-nd/4.0/
前の記事 次の記事
feedback
Top