鉄と鋼
Online ISSN : 1883-2954
Print ISSN : 0021-1575
ISSN-L : 0021-1575
複合吹錬法によるステンレス鋼高炭素濃度域の脱炭反応特性
中尾 隆二田中 重典高野 博範森重 博明
著者情報
ジャーナル オープンアクセス

1996 年 82 巻 4 号 p. 273-278

詳細
抄録
From the results of the experiments using a 100kg induction furnace and a 60ton AOD, it was found that efficiency of decarburization with the combined blowing became larger than that with the top blowing or the bottom blowing. It was suggested that the formation and reduction of (Cr2O3) in the hotspot with high temperature have influenced on decarburization reactions. The decarburization potential by chromium-oxide (CRP) was definded as the sum of the discrepancy (-ΔG) from decarburization reaction equilibrium by (Cr2O3) in hotspot and bulk of metal, and experimental results were evaluated by using CRP.
There were good correlations between efficiency of decarburization and the value of CRP in every oxygen blowing types.
The decarburization rate was controlled by the balance of oxygen blowing rate and rate of carbon supply and conditions of reaction zone, and the decarburization by combined blowing with hard top blowing was promoted by the reduction of (Cr2O3) in hotspot region.
著者関連情報
© 一般社団法人 日本鉄鋼協会

This article is licensed under a Creative Commons [Attribution-NonCommercial-NoDerivatives 4.0 International] license.
https://creativecommons.org/licenses/by-nc-nd/4.0/
前の記事 次の記事
feedback
Top