The ability of Climacodon septentrionalis to immobilize and kill a mycophagous nematode (Aphelenchoides sp.) in vitro is described for the first time. Two isolates produced droplets (20–45 μm in diameter) that formed at the apices of tall, stalked, and branching secretory cells (700–1,500 μm tall). On 2% modified malt extract agar, nematodes became enveloped in the droplets, which restricted their ability to move and resulted in complete immobilization and death within several hours of contact. The rate of decomposition of the nematodes varied considerably, with most individuals persisting for weeks whereas others were degraded within several days and appeared to be colonized by dense hyphal growth. This study provides the first documentation of a non-agaricoid fungus producing secretory cells that are able to immobilize nematodes.

抄録全体を表示

The possibility of attenuation of microseismic waves due to the presence of an upward folding of the ocean bottom into the liquid is discussed in this paper. The upward folding of the ocean bottom has been idealized by means of an irregularity in the form of a rectangle intruding into the liquid and the evaluation of the displacement component at any point of the solid medium has been carried out in two stages. First, the change in the incident mode of the surface wave due to the presence of the rectangular irregularity has been determined, and second, the subsequent change of the resulting displacement components due to the termination of the liquid layer and the step change in elevation of the solid medium at the continental margin has been discovered. Finally, numerical calculation has been made to determine the attenuation of the microseismic waves of different periods due to the presence of the rectangular irregularity at the ocean bottom.

抄録全体を表示

A sample of [³H] tobrarnycin (, 000 Ci/Mole) has been synthetized and incubated with
the bacterial ribosome and its subunits. The results obtained show that this antibiotic has
two types of binding sites. The primary one is probably responsible for the inhibition of
protein synthesis whereas the secondary one is probably related to the misreading and reading
tiirough of the messenger RNA.

抄録全体を表示

The paper presents results from an extensive experimental model study of response of dry sand to impact of a rigid tamper. In the laboratory tests a circular steel tamper was repeatedly dropped on sand contained in a large tank. Measurements included tamper acceleration aud soil pressure at impact, tamper settlement, aud soil densities and strains. Effects of tamper drop height, weight and contact area were investigated. A method is presented for the evaluation of global dynamic stiffness of the soil mass affected by the impact by calculating a dynamic settlement modulus (DSM). The DSM values are determined from integration of the impact acceleration record with respect to time using measured integration constants. DSM values show good correlation to soil densities and corresponding elastic moduli obtained from laboratory tests for loose sand. However, for dense sand, results indicate apparent discrepancies between elastic modulus and the higher DSM values. Analyses of normalized impact energy and the resulting densification in the sand in terms of normalized dimensions of volumetric strain (relative density) contours show unique correlations which are used for a proposed rational design method for dynamic compaction in dry sandy soils.

抄録全体を表示

The phase diagrams of the Ni-Mo- and Ni-W- ternary systems in the region of less than 50mol% were constructed by thermodynamic calculation, based on the data obtained by thermodynamic measurement of the related materials. We found three ternary eutectic points and three or two ternary peritecto-eutectic points as follows:
:L (1365K, 71.mol%Ni-6.mol%Mo-.mol%)=(Ni)++
:L (1355K, 62.mol%Ni-2.mol%Mo-30.mol%)=++
:L (1445K, 42.mol%Ni-30.6mol%Mo-10.3mol%)=(Ni)+NiMo+
P₁:L (1812K, 34.mol%Ni-42.3mol%Mo-.mol%)+MoB=+
P₂:L (1633K, 42.3mol%Ni-40.mol%Mo-17.3mol%)+Mo=+
P₃:L (1812K, 53.mol%Ni-33.mol%Mo-12.mol%)+Mo=NiMo+
:L (1622K, 51.mol%Ni-31.6mol%W-17.mol%)=(Ni)+W+
:L (1260K, 71.mol%Ni-.mol%W-.mol%)=(Ni)++
:L (1291K, 65.mol%Ni-.mol%W-29.mol%)=++
P₁:L (2115K, 23.mol%Ni-43.1mol%W-33.1mol%)+WB=+
P₂:L (1657K, 48.mol%Ni-33.1mol%W-18.mol%)+=W+
The calculated phase diagrams are expected to be useful for the development of new Ni-based heat-, corrosion- or wear-resistance alloys.

抄録全体を表示

A comparative study of the static and dynamic response of a slope is carried out, using the large deformation theory of the updated Lagrangian formulation and the conventional infinitesimal theory. In the static analysis, a strength reduction method proposed by one of the authors is used to evaluate the safety factor of the slope. It is found that by the large deformation theory, the safety factor is larger than that calculated by the infinitesimal theory, and this difference becomes large along with the reduction of elastic modulus. In the dynamic analysis, it is observed that the large deformation theory gives smaller sliding displacement and larger response acceleration than the infinitesimal approach. It is concluded that in many cases the large deformation approach gives more adequate solutions.

抄録全体を表示

The effect of composition and controlled thermomechanical process parameters on the mechanical properties of HSLA steels is modelled using the Widrow-Hoff's concept of training a neural net with feed-forward topology by applying Rumelhart's back propagation type algorithm for supervised learning, using a Petri like net structure. The data used are from laboratory experiments as well as from the published literature. The results from the neural network are found to be consistent and in good agreement with the experimented results.

抄録全体を表示

[1] The purpose of this reserch is to make clear what type of design can give good effects to win the high readership score. At the begining I had to know what factors decide the readership score, and how to change the quality of the desing into numerical value. I have used the method of multi-dimentional analysis with the help of a computer, and got the estimation formula, with kinds of factors, as follows ; A^^〜=+C+D+K++bF+cG. A^^〜=estimated values of the readership score. 1) , C, D, K : these four factors are given as category values (so we call them); each factor is classified into several categories. =week day, classified into categories. C=pages of a newspaper, which are characterized by the kinds of articles, news, and the other reading matters, classified into categories. D=kinds of goods and trades of the advertizement, classified into 14 catedories. K=constants, given to each 13 surveys. 2) , , G : these factors are given as numerical values. G=area of advertizement, measured by the unit of column in the whole page length, being classified into 6 kinds of area (2., 3., , , 10, 15) and 15 column means a whole page, about 2,000cm^2. , are the marks obtained in the design of advertizements. =sum of the marks obtained in each design element on the advertizement. =the marks obtained on the whole effect of the design. 3) a, , c : coefficients Using the above formula with the category values and the coefficients, we can obtain the naked design effect from the actual value A of readership score: +bF=A-(+C+D+K+cG). In this research, I used 1,829 data of readership score from 1960 to 1968, being obtained by 13 survevs, spring and autumn twice a year. The sample of size each survey was 3,541, 2,251, or 200 in the other 11 surveys. Multiple correlation coefficient between the estimated value A^^〜 and the actual value A is .951. The table 2^* shows the contribution indexes of each factor by 3 kinds of expression-(1) Range : the absolute difference between the maximum and the minimum category values, (2) Standard deviations of the category values, (3) Partial correlation coefficient : the relationship between the actual values A and each factors. *see the table 2 in the thesis in Japanese. [2] The important point was in the determination of the values of , . is the sum of the marks obtained in each design element, classified into four kinds : =_1+_2+_3+_. design elements [table] _1, _2, _3, _, these values have the grades, as , 1, 2, 3, and is given to the design that has no attractive effect or no applicable element. And obtain the marks of to grades as the sum of them. The values of have also grades, to . The principles to determine the values of , are as follows : a) The marks obtained of , must be the relative values among the each survey, and at the same time, they must have constancy within the same survey-the same elements of design must win the same marks obtained. ) They must be determined as to win the highest multiple correlation coefficient, when they are put into the estimation formula. c) They must be reasonable. In order to justify them, we must carry many researches on the actual condition. The frequency of accurence of each grade of , values, as the table -, and - in the thesis in Japanese.

抄録全体を表示

An unsupervised learning technique and an associative memory have been used for encoding weights by a special type of Petri network named Petri neural net for modelling the influence of alloying elements on the final property of the high strength low alloy steel. The combined effects of alloying elements for different strengthening mechanisms is predicted when weights and threshold values are chosen on the basis of metallurgical understanding. The technique is found to be effective to create an associative memory of input-output relations in unknown data sets so that the same can be subsequently be used as a predictive tool.

抄録全体を表示

Primarily from the point of view of improvement of yield strength due to additions of niobium, titanium and boron in HSLA steels, the experimental steels are divided into five classes. The data are then supplied for learning a Self Organising Map (Kohonen network). It is found that the network with six neurons possesses better capacity of prediction with unknown data. Another effort of clustering the steels according to its major strength contributing mechanisms is also made. But the capacity of the network to cluster unknown data is found to be rather poor and has failed to follow from the metallurgical principles. To avoid this limitation, Learning Vector Quantisation method is adopted to impart a certain amount of supervision in the learning process and it is found that the training pattern of the network attains a good convergence thereby leading to a good predictive ability.

抄録全体を表示

A boron treated copper bearing HSLA steel containing austenite formers like manganese and nickel, somewhat lower in amount than that in HSLA 100 variety of steel is chosen for the study. The role of thermomechanical processing on the microstructure and mechanical properties of the above steel has been investigated. Differential scanning calorimetric study is carried out for understanding the precipitation behaviour of copper in HSLA steel under the influence of boron. The microstructure of the experimental steel is found to consist of laths of martensites and bainite. MA constituents of ribbon like morphology are observed at the lath boundaries. Higher strength properties of the steel are attributed to the presence of finely distributed precipitates of copper and microalloy carbides.

抄録全体を表示

The Gujarat earthquake in India occurred in January, 2001, and caused significant damage in the province of Gujarat. The Japanese Geotechnical Society sent a small reconnaissance team to the damaged region after the quake. The present text presents the report from this activity. The major attention of the team was focused on geotechnical aspects of the damage which were related to earthfill dams and harbor land fills. It was found that a significant portion of damage was concentrated in fills resting on soft natural soils. Swedish weight soundings which were conducted at two places demonstrated the existence of such a soft subsoil. From this, it was concluded that amplification of earthquake shaking as well as the permanent deformation in the soft foundation soil induced such kinds of damage as subsidence, cracking, and lateral spreading in overlying artificial fills. For the better seismic resistance of those affected fills during future earthquakes, the improvement of soft subsoil seems essential.

抄録全体を表示

The boundary element method expanded in frequency domains is presented to analyze the dynamic interaction between an embedded flexible rectangular foundation and soil with consideration of the obliquely incident waves. Numerical results describing the influence of the flexibility of the foundation on the dynamic responses of the foundation due to obliquely incident waves indicate that the flexibility of actual foundations can diminish the reduction of translation responses and increase the rotational responses in the high frequency range. These phenomena are more conspicuous as the embedment ratio is larger and the value of the wave velocity ratio of the soil and the foundation approaches to unity. When the high frequency components of the input ground motion are important and the basement has higher flexibility (for example ₂v_s/₁v_s >.), the analysis method which considers the basement as a rigid foundation may lead to unsafety estimations and the estimation of the flexibility of the foundation is necessary as analysing the effective input motion with consideration of the incident waves.

抄録全体を表示