Automatic Flatness Control of Cold Rolling Mill

Abstract

One of the subjects of cold rolling is a flatness of the rolled strip. Conventionally, measured strip flatness was approximated by polynomial (2^th, 4^th, 6^th) equation across the entire strip width. This made it difficult to deal with desired loose edge or any desired flatness across the entire strip width. Also conventional flatness control was done for the entire strip width, so if there is a different flatness error among drive side and work side, conventional flatness control can not control properly. We propose independent strip flatness control among drive side and work side, and also automatic flatness control (AFC) system with arbitrary desired strip flatness. Also some applied results to cold mill are shown.