International Journal of Automation Technology
Online ISSN : 1883-8022
Print ISSN : 1881-7629
ISSN-L : 1881-7629
Special Issue on Advanced Abrasive Process Technologies
Automating the Mold-Material Grinding Process
Takekazu Sawa
著者情報
ジャーナル オープンアクセス

2019 年 13 巻 6 号 p. 722-727

詳細
抄録

Grinding is difficult to control because abrasive grains are scattered randomly on the surface of the grinding wheel, and the quality of the grinding work is strongly dependent on the skill of the operator. Therefore, automation and optimization technologies should be established immediately for grinding, along with other machining work. From this perspective, we observed the bending vibrations of a diamond wheel during a grinding project and developed a technique to identify the grinding condition by using a microphone to measure the small noises from the vibration (called bending-vibration noise in this paper). In this paper, we report the application of the technique to an ordinary grinding wheel, and our attempt to automate the grinding work of STAVAX and SKD11 metal materials.

著者関連情報

この記事は最新の被引用情報を取得できません。

© 2019 Fuji Technology Press Ltd.

This article is licensed under a Creative Commons [Attribution-NoDerivatives 4.0 International] license (https://creativecommons.org/licenses/by-nd/4.0/).
The journal is fully Open Access under Creative Commons licenses and all articles are free to access at IJAT Official Site.
https://www.fujipress.jp/ijat/au-about/
前の記事 次の記事
feedback
Top