Reduced Numerical Modeling of a High Head Francis Turbine Draft Tube at Part Load

抄録

In the present study, a reduced model of the Francis-99 model turbine was investigated numerically at part load operating condition. The reduced model consists of a standalone draft tube domain of the Francis-99 model turbine. Numerical studies performed in the past on nearly complete hydro-turbine models (inclusive of the spiral casing, distributor domains, runner, and draft tube) reportedly consist of a large number of computational grids. This may increase the computational costs and data storage required to perform numerical analysis, which could be a setback for future research on new design concepts and optimization study of the draft tube domain. The reduced model was developed by mapping the phase averaged axial, radial, and tangential velocity profiles from the runner exit to the inlet of the standalone draft tube domain. Additionally, turbulent kinetic energy (k) and turbulent eddy dissipation (ε) variables were also considered for better flow prediction inside the draft tube domain. Two methods for mapping inlet boundary conditions were considered in the present study. In the first method, the entire planar profile of the runner-draft tube interface was considered. In the second method, the variables along a radial profile at the runner exit were considered with an axis-symmetric flow assumption over the entire draft tube inlet plane. The numerical results obtained from the Francis-99 reduced model turbine were validated against the numerical model of the NVKS Francis-99 model turbine (with available structured mesh) that was also analysed using the passage flow numerical technique and available experimental results. The results were found to be in reasonable agreement, with each other. The present study could be useful for the future mitigation study of rotating vortex rope by modifying the draft tube domain.