Journal of Advanced Mechanical Design, Systems, and Manufacturing
Online ISSN : 1881-3054
ISSN-L : 1881-3054
Papers
Development of a 2-DOF Controlled Magnetic Drive Actuator for Laser Beam Cutting
Xiaoyou ZHANGTadahiko SHINSHITeruaki FUKUOKATakahiro NAKAI
著者情報
ジャーナル フリー

2013 年 7 巻 3 号 p. 448-457

詳細
抄録

Laser beam cutting (LBC) is a non-contact machining method that is widely used in industry. In order to improve cutting speed and reduce the consumption of assist gas, it is necessary to employ a machining method that applies a suitable eccentricity between the laser beam axis and the assist gas nozzle axis. This paper describes the development of a high-speed, high-precision, magnetic drive actuator, which can be attached to a conventional LBC machine to control the relative displacement between the laser beam axis and the assist gas nozzle axis in two orthogonal directions. First, a magnetic drive actuator is designed and fabricated. In the actuator, the motions of the lens in the radial directions are controlled by electromagnets, and the motions in the other directions are constrained by elastic hinges. Second, a compensation method for the zero point of the displacement sensors that are used to measure the displacements of the lens in the radial direction and an adaptive control method for the actuator are presented. Finally, the effectiveness of the presented control method is verified, and the positioning performance of the actuator is evaluated through experiments. The experimental results showed that the vibration of the lens was reduced using the presented control method, and the actuator had a positioning resolution of 0.75 µm, a bandwidth greater than 133 Hz, and a positioning stroke of 1 mm.

著者関連情報
© 2013 by The Japan Society of Mechanical Engineers
前の記事 次の記事
feedback
Top